The design is based around the FTRQ from FTDI and provides the user with multi baud rate serial data up to 3M baud rate. Standard ” pitch 5 pin female. FTDI FTRQ: available from 4 distributors. Explore Integrated Circuits ( ICs) on Octopart: the fastest source for datasheets, pricing, specs and. The FTR is the latest device to be added to FTDI’s range of USB UART interface Integrated Circuit Devices. The FTR is a USB to serial UART interface.
|Published (Last):||27 February 2013|
|PDF File Size:||8.1 Mb|
|ePub File Size:||13.48 Mb|
|Price:||Free* [*Free Regsitration Required]|
No USB-specific firmware programming required. The devices can acknowledge USB bus data, capable of operating up to kbps, with low power consumption 8 mA.
Propeller restarts 50 ms after RESn transitions from low to high. It can then be used to protect customer application software from being copied. When looking at the Prop demo board shown below, it shows a different part for the FTRQ than what actually appears in Eagle.
Royalty-free drivers for the most common operating systems are available ft223rq FTDI website. I justified the need based on the fact that maybe there could be a case where the FTDI drivers weren’t installedor some other driver conflict, and someone needed to update a program.
I’d say the eagle part is ok.
Comments 7 Comments sorted by Date Added Votes. It also lists a lot of Cbus pins.
RS Components Statement of conformity. Standard Pack Production Pack.
I uploaded the Eagle parts as they are labeled, I think that someone has the parts reversed in Eagle. Schematic symbols are often setup to make it easier for the overall schematic, for instance the oscillator pins are drawn further apart to accommodate the symbol for a crystal close to the CPU.
Asynchronous and synchronous bit bang interface modes are also available. Clearly the Eagle Library is wrong but I wanted to make sure.
Radio messages are sent and The product detailed below complies with the specifications published by RS Components.
FTRQ – FTDI – C1S – datasheet
The product does not contain any of the restricted substances in concentrations and applications banned by the Directive, and for components, the product is capable of being worked on at the higher temperatures required by lead—free soldering The restricted substances and maximum allowed concentrations in the homogenous material are, by weight: They enable USB to be added into a system design quickly Ok one more thought, the reset transistor from the FT Prop Demo is looking at a cap, which can’t pass DC, only transients.
Also included on the board is power supply filtering, antenna-trimming capacitor and LEDs for visual indication of card acceptance. I was purely guessing to use just one transistor, sum the two DTR’s with a 1k into the single AC coupling cap which should still produce a transient. The RESn is active low. The product does not contain any of the restricted substances in concentrations and applications banned by the Directive, and for components, the product is capable of being worked on at the higher temperatures required by lead—free soldering.